(ENG,KOR) [Bell Media] TSN Raptors Calibration Process

Owned by Joowon Hong (홍주원) (Unlicensed)
09/27/2023
4 min read

Calibration Option 1 (Recommended)

Advice:
It is best to use a puck or soccer cone (that was left behind) to see the points clearly

Is where the tripod should be located when doing the 2D calibration

 

Option 1: shall be used when the operator is able to see the end of the three point line corners and also the center line of the court.

 

If the operator is able to see that, the operator shall place:

  • Point 1: Left corner of the three point line

  • Point 2: Left side of the corner of the center circle

  • Point 3: Right side of the corner of the center circle

  • Point 4: Right corner of the three point line

* Same at the opposite side

Calibration Option 2

Advice:

It is best to use a puck or soccer cone (that was left behind) to see the points clearly

Is where the tripod should be located when doing the 2D calibration

 

Option 2: shall be used when the operator is unable to see clear of the end of the three point line corners(both sides) and also when the center line of the court/circle is not visibly clear.

 

If the operator is unable to see clear of the end of the three point line corners and also not the center line of the court/circle, shall place points on:

  • Point 1: Bottom corner of the box key

  • Point 2: Top corner of box key

  • Point 3: Opposite top corner of the box key

  • Point 4: Opposite bottom corner of the box key

* Same at the opposite side

 

Calibration Option 3

Advice:

It is best to use a puck or soccer cone (that was left behind) to see the points clearly

Is where the tripod should be located when doing the 2D calibration

 

Option 3: shall be used when the operator is able to see clear of the end of the three point line corners(both sides) but the center line of the court/circle is not visibly clear.

 

If the the operator is able to see clear of the end of the three point line corners(both sides) but the center line of the court/circle is not visibly clear, shall place points on:

  • Point 1: Bottom corner of the three point line

  • Point 2: Top corner of box key

  • Point 3: Opposite top corner of the box key

  • Point 4: Opposite bottom corner of the three point line

* Same at the opposite side

 

Points on Tripod

 

As you can see, There are total of x6 Yellow tapes.

  • Two tapes on the top (Orange Circle)

  • Two tapes in the middle (Pink Circle)

  • Two tapes at the bottom (Red Circle)

 


* However, there is a gap between the two tapes in every location where that is the  “point” that needs to be selected when doing calibration

 

On the next page I have attached a more zoom in picture to be more clear.

 

I. Points on Tripod (Top of the Tripod Point for the Calibration)

II. Points on Tripod (Middle/Bottom of the Tripod Point for the Calibration)