| Table of Contents | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Check Bandwidth
| Note |
|---|
Before starting the service, it is necessary to check the bandwidth to ensure that the network speed does not affect the service between PostSd PostSD and AWS, between PreSd PreSD and the Camera, and between PreSd PreSD / PostSd PostSD and VPdthe VPD’s. |
Bandwidth Check List
PostSd PostSD to AWS
PreSd PreSD to Camerathe Cameras
PreSd PreSD /PostSd PostSD to VPdthe VPD’s
PostSd to AWS
| Note |
|---|
When using the 4DLive system, check the bandwidth checks from the 4DRS between the AWS 4DRS and PostSd PostSD are performed in advance through a specific program in order to smoothly transmit and receive video data. |
...
Steps to install iperf or iperf3 on the 4DRS
Install iperf or iperf3 on 4DRS systems on the AWS
Move and copy C:\Users\4Dreplay\Downloads\iperf 3.1.3-win64\iperf-3.1.3-win64
...
Run Command Prompt and copy 'cd'
Enter
...
[Steps to perform bandwidth check]
Step 2 In the path (for version 2,) enter 'iperf -s' (for version 3,) 'iperf3 -s'
Enter
Install iperf or iperf3 the same on your PostSd PostSD system
Step1 Copy the same file location as
(For version 2) Type 'iperf –c 10.82.7.214'
(For version 3) Type 'iperf3 -c 10.82.7.214'
If you enter it, you can check the bandwidth as shown on the left.
...
| Note |
|---|
When using the 4DREPLAY system, bandwidth checks are performed in advance to receive ensure smooth video data. |
...
[Steps to install iperf on
...
PreSD]
Install iperf on PreSd PreSD PC
Move and copy C:\Users\4Dreplay\Downloads\iperf 3.1.3-win64\iperf-3.1.3-win64
...
Run Command Prompt and copy 'cd'
Enter
...
[Steps to perform bandwidth check]
Step 2 Enter 'iperf -c camera_IP address -p 50000' in the path and enter
If you press Enter, you can check the bandwidth as shown in the picture on the left.
※ If you enter 'iperf -c camera_IP address -p 50000 -i 1 -t 15', check the speed every 1 second and repeat 15 times.
※ The network speed between PreSD and the camera section is measured only by iperf (version 2)
...
PreSD/
...
PostSD to
...
VPD’s
| Note |
|---|
You can check the bandwidth between PreSd the PreSD and PostSd and VPd through PostSD and the VPD’s on the Log button which is located at the top of the middle of the 4DDM program. PreSd PreSD and PostSd PostSD can be selected either one or All, but VPd VPD’s can only be set to All“All” |
...