Start View
When running the 4DPD program, this is the first screen that pops up. In this window, the operator can directly enter the IP address of the PC to run each daemon, the same as in 4DDM. To start the 4DPD program, you must go through the Start View.
Step 1.
[Daemon registration steps]
Verify that all required daemons are running at PD (CCd, EMd, GCd, PCd, MTd, SCd daemons are running)
※ If not running, click Control View - Process ON via ACLaunch PD by clicking the 4DPD icon on the desktop
Click Set Control Daemon IP, set the IP address of the PC where CCd, SCd, GCd, and PCd are running, and click Save.
Step 2.
[Steps to run a PD]
Enter the Main Control PC IP address in Master PC IP
Click Connect
0 Comments